Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!





Dodge Intrepid

1124125127129130166

Comments

  • smithedsmithed Posts: 444
    I suspect the difference in resale value percentage you are talking about has more to do with SUV versus sedan than Dodge vs. Ford. Tauruses (and Impalas) lose there value at about the same rate as Intrepid and Grand Cherokees hold their value like Explorers. It has more to do with the type of vehicle. Neither Ford nor Dodge sedans will hold value like a Camry or Accord.

     

    My '99 ES has the 3.2. It was bought to last for years, with no plan to trade at any time. It has done great so far (6 years and 95,000 miles)
  • I agree that the Ford Explorer is a very popular SUV, and mine was a lemon However, I must have side-tracked you folks, because it doesn't seem that my original post (#2657) received any comments. I just want a little information, if possible.
  • andre1969andre1969 Posts: 21,587
    sounds like it might be something called a "hot start" problem. Even though you've let the car cool down for a half hour, depending on how long it was run before, and the temperature outside, the engine could still be pretty hot.

     

    Unfortunately, it could be just about anything. On an older car, you could just blame it on vapor lock or something in the throttle/idle linkage, but with newer cars, god only knows!

     

    When is the last time the car was tuned up? It might just need new spark plugs and a few adjustments here and there. Might also be one of the spark plug wires. As they age, they can cause seemingly strange, random, intermittent problems. Spark plug wires don't need to be replaced nearly as often as those older style ones that just popped off, but they're still going to wear out, eventually.
  • mike372mike372 Posts: 354
    and its getting more difficult to find them these days...........Daimler Chrysler reported a 9% increase in new vehicle sales for the month of January, largely due to the new 300. On a technical note, spark plug wires can be tested for resistance with an inexpensive ohm meter. I am not sure what the max reading would be on an Intrepid, but most repair manuals would probably have this info. Alot of people, including myself, have replaced wires hoping to solve a 'miss' problem only to find out that it did not improve engine performance.
  • tkfitztkfitz Posts: 95
    Every once in a while my car runs rough for a few seconds after starting when warm too. Never cold and not after just running. It has done this for some time. Lasts about three or four secs. I think it might be fuel related...a slight delay in the fuel pump kicking in. It is gone so quickly that I have never gone further with it.

    Let us know what you find out.
  • andre1969andre1969 Posts: 21,587
    over the 101,000 miles that I've had my Intrepid, there has been maybe 3 or 4 times that it's stumbled a bit, when just starting up. I don't know if this is the best way to explain it, but it seems like sometimes, when I turn the key, it just barely catches, and seems like it's not running on all the cylinders. It'll run rough, but then if I turn it off and then back on, it runs just fine.

     

    For lack of a better word, it seems like an "incomplete start" ? Like maybe I just didn't have the key turned to "start" for long enough, and that might've confused the part of the computer program that controls the spark/idle/etc?
  • I think that you folks might have given me information that might lead to the fix, I really think that fuel scheduling could be the problem, as it seems to be getting a little worse as time progresses.

    As I live in Washington state, I don't think that "Hot Start" has anything to do with it in February.

     

    Anyway, many thanks to those of you that responded to my question.
  • mike372mike372 Posts: 354
    The occasional starting problem you describe with your Trep is now happening with my Celica. The manual says to check the resistance of the primary and secondary ignition coils which I did and they checked out OK. They say next to check out the resistance of the ignitor which is somewhere in the distributor housing. I have not done this yet. Then it says to check the gap of the plugs, which checked out OK. The car always starts after cranking awhile, and it definitely seems not to be running on all cylinders until approx 30 seconds and I also see smoke coming out of the tailpipe until it runs correctly.I also notice the smell of gas, it seems like this is because the car is taking so long to start and thus too much fuel is going to the engine. I looked at the plugs and they have no oil covering the electrode. But I cant figure out what is causing the smoke, if this is the excess fuel burning or something else. The smoke does clear up and the engine runs fine. I am wondering if the head gasket is going, just a thought that this is somehow relatd to the hard starting.
  • mike372mike372 Posts: 354
    Well I just learned that a good friend of mine with a Sebring just had the timing chain/belt screw up leading to bent valves. The same complaint that literally 1000's of 2.7L Trep owners are talking about. The car has about 70-75K miles on the odometer. The shop (incidently a reputable one) wants 2K to fix the car. Not trying to pick arguments with others on this site, names being withheld, but there are definitely problems with certain DC engines.
  • smithedsmithed Posts: 444
    Is the chain in the 2.7 ever supposed to be changed like the belt in my 3.2, which is due a new one at 105,000 miles?

     

    I had two 2.2 liter fours (a Reliant and an Omni GLH Turbo) that the timing belt went on, but those were non-interference engines, so no damage was done to the valve train either time.
  • andre1969andre1969 Posts: 21,587
    I sent an email to D-C customer assistance, asking about just this topic. Here's the response I got...

     

    "Thank you for your e-mail regarding your 2000 Dodge Intrepid.

     

    The 2.7L V6 engine has a timing chain. DaimlerChrysler recommends that you have

    the chain inspected at approximately 105,000 miles to determine if it needs to

    be changed or adjusted.

     

    I hope you find this information helpful.

     

    Thank you again for writing."

     

    I talked to my mechanic about it awhile back, and he said that as long as I keep up on oil changes, and don't let it run low, it should be good for a long, long time.

     

    I'm at around 101,500 miles now, so I guess it's about time for me to look into it. I think if you get the timing chain replaced, you're supposed to do the water pump as well nowadays, aren't you? I know that water pumps aren't simple bolt-on, belt driven devices anymore, so they're probably a lot more expensive to replace than those of days gone by. Might be worth it to do both the chain and water pump at the same time.
  • smithedsmithed Posts: 444
    If they recommend having it inspected at 105,000 and people have had it break before that, I would think (and I know this is wishful) that Chrysler should be responsible for damage done by a broken chain that happens at 75,000 miles. Only seems right.
  • I have a 2000 ES, with 76k on it.

     

    back in october, i replaced the steering rack myself to save some money (it had gone bad due to an accident a couple years ago)

     

    i went on vacation last month, and when i got back, the power steering was dead. it would turn if i revved the engine, and was going, but otherwise, nothing. i took it to a gemini garage. they have replaced the pump 10 times with pumps from different vendors, and the rack twice, cleaned out all the lines, and even replaced the lines.

     

    every time, they drive around the block, it's fine, but then after a few minutes, it loses power again and stops working.

     

    They've given up and suggest i take it to a dealership, but they also said they talked to mechanics at the dealership, and were told they dont know what is wrong either

     

    luckily they're not going to charge me anything since they couldn't fix it, but now im wondering if the dealership is going to be able to fix it either, since everything has been replaced several times, what else could it be?

     

    has anyone else heard of this kind of problem?
  • mike372mike372 Posts: 354
    is that the guides are supposedly plastic and they can wear out at 70-80K miles, therefore causing the chain to malfunction/break leading to valve damage. I was on some internet site, I cant remember which one, and there was something like 500 complaints within a few month period. I just could not believe reading all the complaints explaining the identical problem....timing chain malfunction/breakage leading to bent valves. Its hard not to believe there is some problem when 100's of people complain about the EXACT same thing. I am sorry, but I do not believe the Chrysler dealers or even DC themselves. This is why DC came out with the 70,000 mile powertrain warranty, which my Trep has. But it does no good if DC isnt going to stand behind their words and not blame damage on the customers. Somehow, most other manufacturers dont have to come out with this 'bogus' warranty, why?, because they make well designed engines. Period.
  • mike372mike372 Posts: 354
    i changed the timing belt and the water pump on the Celica at the same time. The problem is, if you dont, and the car leaks water in the future, you have to go thru all the work of the timing chain/belt all over again. Its just a pain in the butt job which I dont look forward to doing. The Celica actually had a leak in one of the gaskets between the pump and the casing of the engine. The actual pump looked good. But if I didnt replace the pump I would have eventually had to do the whole job over again. I would also recommend buying an OEM belt and water pump. Some aftermarket pumps have inferior bearings in them and some aftermarket belts are designed for several vehicles. I bought Toyota belt and pump from dealer and got 10-15% off list price. The job is just too timeconsuming not to do it right the first time.
  • My 2000 Intrepid's 2.7 liter V6 died last week at 60,000 miles. I am still waiting on the repair estimate from my mechanic. Most likely the timing chain failed and has damages the engine beyond repair, just like thousands of other engines.

     

    I really liked my Intrepid until last week...of course, as mentioned, Chrysler is ignoring their engine problem. Hoping for a class action suit...
  • andre1969andre1969 Posts: 21,587
    maybe I'd better get mine into the mechanic and at least have it inspected! How do you inspect a timing chain, anyway? Wouldn't you have to pull a bunch of stuff out just to do that? And once you got that far into it, shouldn't you just go ahead and replace it anyway?

     

    I'm really not *too* concerned at this point if my engine were to go out on me, as the car does have over 100,000 miles on it and it's paid for. At this point though, I guess if the engine blew the car would be totaled. It would suck having to go get another car and get back into payments again, but at least it's not as bad as having something crap out on you while you're still paying for it!!
  • mike372mike372 Posts: 354
    You have been pretty fortunate to get 100,000 plus miles out of the 2.7L engine. It seems to me that most manufacturers recommend replacing the belt/chain, guides, etc when the car hits the 100K mark. The Celica's timing belt was 'shot' and I was lucky to replace it with the tensioner before the engine blew up. You normally would have to take off the front cover,belts, crankshaft pulley (impossible w/out an impact wrench unless you have some way to prevent the engine from turning), possibly remove the P/S pump, altenator, etc and it can be time consuming, especially if there is no room in the case of a small Celica. Them its tricky to replace it in the correct manner, because, in part, you have to set the #1 cylinder properly before you put on the chain/belt and have to adjust it correctly (to the proper tension). Unless you have time on your hands I would recommend bringing the car to your mechanic. My girlfriends Civic is approaching the 100K mark and I will not attempt to replace the belt cuz its very aggravating job that tests my patience. However, if you plan to have some wheels to drive you had better look into it before you are forced to get a new car. Maybe just trade it in now while its still worth some $$??. And, next time (I know you are a Mopar fan), get something that does not have so many complaints on the web.
  • smithedsmithed Posts: 444
    You guys are making me nervous about the 96000 miles on my 3.2 timing belt. I have been planning to wait to 105,000 miles do have this job done, as the manual says This discussion of ruined engines concerns me even with the 3.2.
  • andre1969andre1969 Posts: 21,587
    how come there are two different intervals listed for the Intrepid 3.2? At least, on the 2000 there are. California models are recommended at 105,000 miles, while the rest, "Federal" are recommended at 100,000. Is there really a difference between the two?

     

    It's the same for the 3.5, starting in 2000. For some reason, the Gates catalog I'm looking at doesn't go up past 2000. Also, interestingly, the 3.2 appears to be an interference engine, while the 3.5 is not. Odd, considering the 3.2 is based on the 3.5.
Sign In or Register to comment.