Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Chevrolet Colorado



  • ocmike3ocmike3 Posts: 232
    from Car Connection for June 20th: - 6.S173.A10555.html

    "HUMMER, Colorado/Canyon Bump Up, Too
    The 2007 editions of the Chevrolet Colorado, GMC Canyon and HUMMER H3 will benefit from boosts to the displacement of their engines. The base engine in the pickup trucks is now a 2.9-liter four, up a tenth of a liter and producing six percent more power than the previous edition. The H3 and four-wheel-drive, crew-cab versions of the trucks add a 3.7-liter in-line five upsized from the prior 3.5-liter version. Power output on the 3.7-liter engine is 242 hp and 242 lb-ft of torque, an increase of 22 hp and 17 lb-ft. The larger engine is also available optionally on other pickup body styles. "
  • mike2250mike2250 Posts: 29
    I have to agree, at first I was apprehensive about the power of an I5. Since buying mine, I have added the K&N filtercharger and modified the right front fender to allow for direct airflow. Along with a couple other little tweeks; my Z71 crew cab can not accelerate without the posi locking up. The other day on the interstate, cruising at 80, I had need to punch it. The truck settled and then took off like a shot to over 95 in what appeared to be a split second.
  • leadfoot4leadfoot4 Posts: 593
    I had heard rumors of a "tire recall" shortly after I bought my GMC Canyon (a Colorado cousin) back in January of 2005, however I never got any notifications from either GM or the dealer. It would be a moot point, though, because I put a set of 16x8" rims on it, with a set of 245/75-16 Firestone Destination LEs.

    The good news is that the truck now handles and rides quite well. The bad news is that it was $$ out of my pocket. Now, if I could just get rid of the wind noise in the cab, I'd be really satisfied with the truck.
  • temj12temj12 Posts: 451
    Look at how your bed lines up. There have been posts going back sometime ago that talked about the bed being out of line and having the dealer line it up. Mine was out of line and I had the dealer straighten it up. GM, How hard can it be to line up a bed off the assembly line? I would never have noticed if the posts had not been here.
  • leadfoot4leadfoot4 Posts: 593
    Temj, I appreciate the tip, however I was involved in that discussion last year, and my bed lines up quite well. I've been installing sheet sound deadener, and although I've knocked the noise level down quite a bit, it's still annoying. It's VERY noticable in a crosswind.
  • ocmike3ocmike3 Posts: 232
    see post 948
  • mike2250mike2250 Posts: 29
    I have to wonder if you have window vent shades on your truck and if so, the exterior mount or channel mount. I have the exterior mount and have little if any wind noise. Just my $.02 worth.
  • KCRam@EdmundsKCRam@Edmunds Mt. Arlington NJPosts: 3,495
    And here is confirmation from GM, with complete engine specs:

    GM Press Release - 2.9 I4 and 3.7 I5

    kcram - Pickups Host

    KCRam - Pickups/Wagons/Vans+Minivans Moderator

  • leadfoot4leadfoot4 Posts: 593
    Mike, I do have the window shades, and yes, they're the exterior mount. I put them on right after I bought the truck, and thought that they might be contributing to the noise. In order to verify the problem, I took them off, and there was no difference, so they went right back on.

    It's just a "buffeting" sort of noise, right around the rear window/"B" pillar...regular cab. It's certainly not deafening but is annoying.
  • mike2250mike2250 Posts: 29
    Do you think the window has to come up in the area where the noise is coming from. The same for the door; perhaps it isn't sealed good enough. I know what you mean by a buffeting noise and it can be extremely annoying. Good luck with your search.
  • crsdlscrsdls Posts: 4
    I have a 2004 Chevy Colorado Crew Cab with bad tires. My tires squeal when I go around a corner (No speeding) and they don't hold well on wet pavement and all my dealership told me was a front end alignment and I'd have to replace my tires and I have the extended warranty and it doesn't cover any thing like this. Does anyone have any ideas for me? I am not happy with my truck right now. :cry:
    :lemon: :confuse:
  • crsdlscrsdls Posts: 4
    I don't want to sound Stupid but what is TSB? And where can I check for it?
  • leadfoot4leadfoot4 Posts: 593
    In my past experiences with wind noise due to air leaks around seals, it usually exhibits itself as more of a "whistle". The noise I'm hearing is more of a roar, and seems to be outside and around the rear of the cab.

    As has been mentioned in the past, there have been cab/bed alignment issues mentioned. What I think I'll do next is check to see if the cab is "square" to the chassis, adjusting if necessary. Then, if any adjusments need to be done to the cab, I'll readjust the bed as needed.

    I've added some of the self adhesive, sound deadening material sheets made by Cascade Audio Engineering, to the back and roof of the cab. That helped a lot.
  • leadfoot4leadfoot4 Posts: 593
    Debbie, "TSB" is short for Technical Service Bulletin. You can check either with the dealer or the National Highway safety website.

    Just as a side note, the OE General tires that came with my Canyon are worse than the "S" word. I have a Z-71 SLE, so I had the 265/75-15s. The second day I had the truck, it was on my trusted friend's alignment rack, as I thought there must have been something wrong with the truck. It was ALL OVER the road! The alignment, however, was OK.

    Since this is primarily a winter vehicle for me, I had 4 Bridgestone snow tires on it a few days later... MUCH better, and snow tires aren't known for "handling".
  • vatakvatak Posts: 8
    I replaced the OE General tires on my Colorado with Goodyear Wrangler Silent Armor. A little more $$$, but these tires are great. I really love the ride in my truck now.
  • johnboyvtjohnboyvt Posts: 6
    If the front tires are badly worn on the insides, get your dealer to look up the TSB for it. I have an 05 with 15k miles and just got the alignment and 2 new tires free. According to the TSB all 04s and early 05s have the problem. Mine was outside of the range for the TSB but they still did it with no questions.
  • jm3004jm3004 Posts: 3
    I know its galling to have to replace perfectly good tires but youll be amazed by the difference.(I was)Theres lots of good choices but from what I see from this forum pretty much anything is better than what GM put on. Now if I can only find someone interested in the set of low mileage generals setting under my back deck lol
  • I went with the Michelin Cross Terrains on my 05 crew cab 2wd. What a difference! Had one general starting to seperate at 17k.
  • pjjbmpjjbm Posts: 12
    You asked the question, "I wonder why the valve springs stick". I have a 2.8 2005 Colorado that had the exhaust valve springs replaced. A GM dealer shop manager told me that they were told that the valve spring vendor shipped GM incorrect weight (too light) valve springs. So much for quality control! :lemon:
  • pjjbmpjjbm Posts: 12
    I have a question on these Rear Vents. Has anyone had them replaced? I found TSB 06-08-66-008 "Revised Pressure Relief Valve Replacement". It contains revised information on the rear vent replacement. My 2005 Colorado has a lot of road noise and you can hear the vents opening and closing when there is wind and the windows are closed. The noise is very annoying. From this TSB, I get the impression that an earlier TSB was replacing the rear vents
This discussion has been closed.