Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!





Toyota Pickup (pre-Tacoma) issues

11718202223

Comments

  • Hi paul, Did you mean tighten rather than release the bleeder screws? Clintb32
  • I have a1986 22R pickup with carburation problems. At startup the engine smokes and idles rough. After several miles of driving the engine smooths out but idles fast. It is past due for smog test and gas mileage is bad. Timing is a little advanced and mixture is lean, hoses and PCV are in order. The O2 sensor was replaced with one from a working engine but the converter is old. At this point I expect both are sooted and need replacing. First, though, I would like to read the codes.
    In attempting to read the codes and understand a little more about the system, I bought a Chilton manual. The Chilton manual for the 86 pickup shows how to jump the two test connector and tells how to read the resulting codes on the instrument panel trouble light. Problem...the connector has three wires and there is no trouble(check engine) light. In an attempt to resolve this little problem I made a visit to Toyota of Huntington Beach where i was told they could not help and besides "we are in business to repair vehicles, not to tell others how to repair their own."
    Other dealers have been more reasonable and I was told to jump the white wire to the light green wire with the red stripe. Then I found there was no light on the panel or on the Chilton schematic. I suspect the third wire may be the answer, but after 50 years in electronics, I hesitate to make unknown connections.
    After many hours on the net, I have not found a phone number or email for Toyota that can answer my question and hope someone on this forum can. It would be greatly appreciated.
  • HI, Just to let you know I'm only a weekend mechanic but this is the same engine as mine. The thermostat is located just behind the 90 deg elbow, on your engine block, were your bottom radiator hose is connected to. There are three nuts holding the right angle elbow to the block. the book says to note witch end is facing up when removing your thermostat. I also had over heating problems on my engine and it turned out that the timing belt was stretched and needed replacing. the timing belt actually runs the water pump behind all the covers on the front of the engine., I did not change my timing belt in time and I blew a head gasket. So its crucial that you fix your over heating problem especially in the winter. I hope that helps. I don't know about the pressure of the radiator cap or the temp. on the thermostat. good luck :)
  • 94 Toyota 4WD, 4 Cyl, pickup

    Was driving down the road, when it started to cut out and died. After waiting awile and continued cranking of the engine the pick-up started up. If driving carefully with throttle the pick ran for awile and then started cutting out and died again. This continued for about 20 miles, until it would not start at all.

    Tried:
    Changing Fuel Filter --didn't work
    cold start fuel port had fuel in intake, fuel system seems to be ok
    I checked ignition, no spark
    There is elect current up to coil but none to distributor.
    Replaced soil, pick-up still doesn't have any spark.

    Any ideas? Thnaks for looking.
  • A few minutes after operating temp is reached, the engine starts missing and I lose horsepower. I am pretty sure the fourth cylinder is not firing. Pulled the spark plug wires one by one - when I pull the last one it has no effect so I figure it's that cyl. I am getting spark to that cylinder, and the plugs are new. Any ideas would be appreciated. Thanks.
  • Check you distributor cap and rotor. If they are fine, then you might want to check the compression in all cylinders.
  • !990 6 cyl. won't hardly pull itself out of driveway. Replaced plugs, rotor, cap, filters. When I hit the throttle it makes a sound like an exhaust leak on pass. side, but I see no sign of a leak. On the road it is a slug until 3000-4000 when it smooths out and pulls good. Sprayed start fluid around vacuum hoses with no change. Any ideas?
  • i have the same problem what did you find out to fix the problem have changed the same things i can mash the gas and it will not move
  • I have a 94 toyota pickup my speedometer don't work well it does sometimes when it rains what should i look for to fix it
  • It sounds like the electronic speedometer connector has a short. I'm not sure about the automatic transmission, but on a manual the connector is on the passenger's side of the transmission, close to the back. It'll be almost the only wires you see coming out of that end of the transmission. Examine the wires, and see if any have rubbed through the insulation to bare wire. If there are bare spots, then maybe you could tape them with electrical tape. If the wires/connector seem OK, then you want to carefully take out the sensor and examine the gear(s) on the end of it. If the gear is worn out, then you'll need a new sensor. If all that seems OK, then you'll probably need to take it into a mechanic, or a specialty shop that deals with speedometers, gauges, and electrical problems.
  • I was given a 85 xcab 4x4 with 119,000 9 years ago. Box was rusted. Since than
    I completely rebuilt the 22R FI engine. Has 2000 miles on rebuilt. All axles and
    Auto trans have amsoil fluid and are perfect. Locking hubs. Cab body in good shape
    with new front fenders. Have snow plowed my driveway for the last 6 years with
    a 6' alumium blade with a western plow frame and controls. Best traction truck
    I have ever seen, but the frame is going fast from rust. Will a newer toyota pickup
    accept the front axle and springs with using my old steering box and steering
    column. Perhaps a 94. Have too much invested in engine and body too junk.
    Truck now has 145,000 on it. Need Advise. Bob
  • zaggizaggi Posts: 2
    I'm looking into buying a friends 89 Toyota pickup for $800, the body is in great shape and the tires are all good. The engine runs pretty well to me, it's a 5 speed tranny and isn't lacking any power it seems. There were a few things I noticed though, in higher rpms there's a quite loud squeal, I'm told it's the fan belt and should be replaced or tightened, sounded true enough to me. Is that something I can easily do myself? Also, if going uphill or even a gentle hill it will pop out of 5th gear, I've heard that a bushing can fix that, though I guess if you're going uphill you don't need to be in 5th gear anyway. I looked over the engine and everything looked okay, I'm not much of a mechanice though. The drivers side blinker is missing, and the bumper is an aftermarket one and is mounted crooked. The grill has a bit damage as if someone hit it with a bat. Just wondering if everyone thought this would be a good purchase. Thanks.
    -Josh
  • Sounds good to me. Belts are cheap enough to replace. $10 each, give or take. The shifter bushings are the likely culprit for the transmission popping out of gear. They shouldn't cost more than $150 at your local mechanic. A turn signal lens/bulb is easy to replace, just a few screws, and the light is most likely available at your local junk yard.
  • zaggizaggi Posts: 2
    Thanks for the reply. I just noticed an error I made in my post, the truck IS an 86, not an 89. But I'm pretty much set on buying it. For $800 I guess I can't go wrong, I know of alot of people who pay $500-$800 on a vehicle that doesn't even run, so I think I'm getting a decent deal here. I'll definitely take a drive down to the local Pick-A-Part junkyard and see if I can't find some stuff to make her look a bit better. :D Anyway, thanks again. Any other advice or tips would be awesome too.
    -Josh
  • For some time now, my 93 pickup with the 3.0 VZE has been sounding like it spark knocks when traveling at speeds above 55mph. It really seems to get bad when the cruise is set at about 65 while traveling on the interstate. When it does this, I let off and then speed back up. This seems to help for a short time until it starts again. I am worried that it is the beginning of big problems, considering it has 168K miles. Does this sound like it is the main bearing or something like lifters ticking? I had one mechanic look at it and he said that it was just old, and things like this are normal. Personally I am afraid to drive it long distances anymore, so I use it as an around town truck. Has anyone experienced the same thing or does anyone know if I just need to have the engine overhauled?
  • esb43505esb43505 Posts: 1
    I'm currently having the same problem, kind of intermittent. '94 4-cylinder. when it's acting up it idles ~ 500 rpm, sounds rough and about to stall out. when driving, I can also floor the pedal and just about no response, then around 3000 rpm there's a surge and the engine starts to pull. I've also replaced the plugs/cap/rotor. some days the truck is just fine. sometimes seems to be associated with damp weather, but not always.
  • pauliep13pauliep13 Posts: 44
    I was having a similar problem on my '95 4 cyl. It was more intermittent, though. It would run just fine when first starting it up. After driving around for a little while and getting the engine up to, or close to, operating temperature, park it for a few minutes to cool off. After restarting, then it would have horrible power in the low end, but it only lasted for a little while until the engine was hot again. It also gave a rich burning smell from the exhaust. I figured out that it might be the O2 sensor, since I recently replaced it, and took it back to the parts store on warranty. Since I've replaced it with the new one, the truck runs just fine. I'm waiting to see if the problem comes back, since this is the first time I've replaced the O2 sensor with an after market one. If this one fails, I guess I'll have to do my best to get my money back and get a Toyota one from the dealer. I guess you should check your O2 sensor and see if the heater element is burned up, or maybe if it's all together bad.
  • jettafacejettaface Posts: 15
    Had this under Tacoma until I saw this site. Adding here.
    Hi, I have a 1989 Toyota SR5 4x4 4 cyc pickup with 66,000 miles on it. I just luv this toy. Friend gave me 2 new exhaust mufflers. Can't find a name on them but they are cyclinder in shape, about 2 feet long and red....I know..nice info. But I was thinking of putting both of these on and now am wondering if I could screw up back pressure, etc.? Maybe I should just leave well enough alone, but I sure would like to hear a little growl when I take off. Second childhood I guess. Any suggestions? Thanks much.
  • ibartrumibartrum Posts: 1
    I have a 94 P/U (V6) that has trouble starting after its been driven more than 20 minutes. It turns over, but then acts like the fuel supply runs out and stalls. If I wait about 15 minutes I can get it to start. Mechanics are mystified...has anyone had this problem? Thanks...
  • toyota18toyota18 Posts: 1
    Hey Shubros or jbryan ,did u find ur problem cause i have the same prob right now and i didnt the trouble yet ! again 91 Toyota starts but wont run more than 2 sec
    Thanks
This discussion has been closed.