Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!





Ford Explorer Air Conditioner and Heater Problems

17810121325

Comments

  • I have exactly the same vehicle (2004 Explorer) and exactly the same problem. If anyone can advise how to check or repair the blend door without dismantling the dash, please chime in. Thanks.
  • mohrlingmohrling Posts: 9
    Blower only works intermittently. I've replaced resistor package with no success. Next applied a 12volt line directly to blower and it turned on. I'm thinking dash switch? Any other place I may look?
    Thanks!
  • mpiacmpiac Posts: 1
    heatertreater, my AC seems to work in that it will put out cool air, but the Max AC portion does not seem to be working. The air output does not increase and the air does not get cooler over time when Max AC is selected. Do you think your blend door fix will take care of my problem?
  • mohrlingmohrling Posts: 9
    OK, so how tough is it to pull the switch? Looks as if the dash may have to go? Anyone?
  • The fan motor is a high current system and there are known problems with the reliability of the wiring over time. The first suspect is always the resistor pack and you have eliminated that as a source of the problem. At the highest speed(max AC) the resistor pack is taken out of the circuit, allowing the full voltage/current sourcing capability to reach the motor and run it at the max speed. Any resistance degradation in the wiring or connectors will be most obvious at full current and the wiring will heat and increase resistance at max load.

    My guess is that you have a bad connector or wiring that has degraded over time and the problem is most evident in full load mode. It won't get better over time and eventually the wires will melt. Check the motor wiring comments on the GC on the www.wjjeeps.com forum for an idea of what can go on with the wiring. I haven't seen reports of the same common problem on the Fords as is apparent on the Jeep, but there's no reason that some systems wouldn't see the same issues.

    My suggestion would be to closely inspect the wiring from the motor to the switch, looking for any signs of burns or melted insulation. If it doesn't look pristine, you've found the problem. I'd also inspect all connectors and remove any signs of oxidation by polishing with steel wool or sand paper. The final resolution may be replacing or patching the wiring/connectors.
  • Not sure what year model you have and the answer is slightly different for different years. Max AC is just fan full blast, re-circ mode on, blend door closed against the heater core. If each of these is working independently, but not together, there is a possibility of a control malfunction, but that's unlikely. If you can isolate the operation of the three functions above, we can make a better estimation of what's going wrong when all three are activated at once. Also, check my answer on this forum on motor wiring, that could also be involved.
  • ryangoryango Posts: 1
    When running the AC on my 2003 Ford Explorer there is cool (not cold) air coming from the passenger side vents, and warm air coming from the driver side vents. I have checked the blend door behind the glove box, and it appears to be operating properly, opening and closing when switching from from heat to and ac and when switching from ac to max ac. Any other suggestions on what to check?

    PS, the refrigerent has also recently been recharged.
  • fizzpotfizzpot Posts: 1
    have an 03 ford explorer - air conditioner not working at all - appears the compressor doesn't kick on - what are the causes/solutions I should first address? thanks
  • mikerusmikerus Posts: 1
    Have a 2007 Ford Explorer. Automatic AC blows cold trough upper vents and to the right footwell and it goes warm from left footwell. So the warmer my feet the colder air blows in my face. A local Ford dealer says: "That's the way it works". But it never worked this way till July, 17, 2009. Does anyone now what the problem is? Need help. Please.
  • talebtaleb Posts: 1
    i have a 99 explorer, my heater and a/c is not blowing any air at all, it just stop working 3 days ago. can u help me? i can hear a clicking sound on the right side, under the hood. i can turn the switch on for a/c and the heater, just no air blowing out of vents at all. please help me. i checked all fuses and they are ok.
  • Thanks! Problem was isolated in the wiring at the motor. This was an easy change out to another blower motor and we've got the A/C blowing again.
  • Hello....my Climate control blows the same in 1,2, or 3 whether it's in heat or AC, I always have to keep it on 4 specially now in the summer and it's too loud on 4 but 1,2,or 3 is the same...would someone tell me where do I start to fix this problem. Thanks
  • dobbsadobbsa Posts: 3
    I have a 1998 Ford Explorer. The A/C works fine at idle up to moderate speeds. Once it is at highway speeds, then the A/C turns warm. When I slow down the A/C gets cold again.

    I don't know if this is a vacuum leak under the hood somewhere, or if it is the under the dash door problem. Any help appreciated!
  • My 97 Explorer Limited with electronic temperature control blower quit working -- the fuses, and motor check out, I changed the blower motor resistor. What do I do next? Thanks
  • I have a 2006 Ford Explorer XLT V6. A week ago, I installed a new stereo head unit into the vehicle. I reconnected all the climate controls wires back into the slots. The illumination works on each of the manual dials, but when you switch the activation dial on the right to one of the fan blowing options, I get nothing. I looked at the fuses, but none of them seem blown. Any ideas would be most helpful?
  • My problem started with the swith over from defrost to front vent heat would take awhile to switch over. Now I have a noise under the dash and no heat
  • My problem started when I would try to switch from floor heat to defrost and to vent exc. Now I have a clicking noise under the dash and no heat! Is there a temp repair until i can get to a repair shop and if so how do you locate the flap Iam hearing so much about
  • I am having this same problem...i have tried doing this already and it is not working...this may sound crazy, but do you have any more specifics on this...the knocking drives me crazy because i need heat!!!
  • leumasleumas Posts: 1
    did you get an answer , i have exactlyu the same problem , no heat and th clicking noise
  • I figured out the problem. The blend door is broken, and i tried what the lady had said to do, but it didnt work. so i bought the part from napa online, and you can replace it by yourself, but it takes some work. i am picking my part up today, which is only 13 dollars, and i am fixing it on saturday. when i get it done i will let you know how it goes! http://www.explorerforum.com/forums/showthread.php?t=214332
    here is the link that i am using to help me with the replacement, and i bought a repair manuel. i am sorry this is all the info i have for now.

    http://www.napaonline.com/masterpages/NOLMaster.aspx?PageId=470&LineCode=BK&Part- Number=6601810&Description=Heater+Blend+Door+Repair+Latch
    here is the link for the part.

    i hope this helps you a little!!

    kasey
Sign In or Register to comment.