Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Isuzu Trooper



  • sbcookesbcooke Posts: 2,297
    What year? St. Charles Isuzu is good for new parts at 10% off.

    I have researched parts and junk yards out of state were willing to ship parts to me. Shipping might up the cost, but try a web search for junk yards and call around.
  • I have seen some folks posting on here with some knowledge of how to clean / replace the range mode selector switch. I took a look under the vehicle, but am not really sure where the switch is. Any additional info would be greatly appreciated. Thanks in advance.
  • uniconunicon Posts: 18
    I feel your pain but you know that that's what always happens after the warranty goes out, something breaks. I had to replace my battery one month after my warranty expired. On my 99 Trooper the same selector switch went out as well. I think it cost $350 parts+labor, and since it wasn't officially part of the tranny, they said the powertrain warranty would not cover it.
  • bsmart1bsmart1 Posts: 377
    I had a problem with my 97' Trooper overheating when the vehicle was not moving. If I came to a traffic stop and had to wait for a few minutes in the heat of summer, the temperature would quickly start climbing toward the HOT area on the gauge. It turned out to be a bad temperature sensitive clutch built into the fan blade assembly. I replaced the metal section built into the center of the fan assembly, and the problem was resolved!!!
  • If you are referring to the mode sensor, read back a few posts. In my post #10862, and Tom's post #10870, we BOTH offered to help some folks with this. If you will email me (link is in my profile), I will gladly send you photos and step-by-step instructions.

  • boxtrooperboxtrooper Posts: 843
    Goto an online classified section like and search for Isuzu Trooper under $1000, there are whole Troopers available for $250. There are 37 Troopers under $2000.
  • My 94 Trooper would not start yesterday. I tried jumping it with no luck. I replaced the battery still would start. the headlights, radio all work. I hear a clicking noise, but wont start. Does anyone have an idea where I should go from here? :confuse:
  • If the starter would not engage and turn when trying to jump start it, it might be a bad starter solenoid or ground cable. Just a guess. Hope it's not the starter, itself.
  • How do you determine if it is a bad solenoid or ground cable?
  • boxtrooperboxtrooper Posts: 843
    If it is a bad ground cable, clamp the jumpstart (-) cable to the engine directly bypassing the ground cable. NOTE: I am assuming the Trooper starter uses the engine block as ground same as nearly all vehicles.
    You may also just have a poor connection in the big wires.
  • bsmart1bsmart1 Posts: 377
    I think you mentioned hearing a SNAP when you tried to start the engine. If so, that is the starter solenoid pulling in to apply power to the starter. It sounds like a DEAD starter to me. :sick:
  • bsmart1bsmart1 Posts: 377
    I've heard several of you talk of putting CD-2 in your oil to reduce 'burn off'. How's it working so far??
  • With CD2 Oil Detergent I've gone from using 1 qt every 500 miles to 1 qt every 2500 miles on both of my '99 Troopers. I ran one bottle in it and then changed the oil 2000 miles later. Ran another bottle on that oil change and went 3000 miles on it. Seeing constant improvement all along I'm now running my Trooper without the CD2 and it's going about 2500 miles before I need to add a quart. I plan on using the CD2 periodically to keep things clean.
  • Yes, SNAP. Do starters go without warning? The day before it was hard to start. It turned over slowly.
  • bsmart1 is dead on! The click was the sound of the solenoid actuating. I believe that a current draw or some such test can identify whether the starter itself is toast, but I'd put my money on that being your problem.
  • emiuraemiura Posts: 59
    Not sure what year your Trooper is, but try All Hyundai and Isuzu Auto Recycling.
  • uniconunicon Posts: 18
    I just put some in my Trooper 99 as it's always burned oil. I'll report back later when I see some results.

    Just replaced the brakes: Front pads, Rear pads and discs. It's an easy job. Have to remove the calipers to access pads. At 75k I still had between 1/8 to 1/4 of pad left.
  • wheels13wheels13 Posts: 51
    Your posting says doing a brake job was easy. How much work is it to get the rotors off the rear? Thank you
  • I have a 99 Trooper (3.5L) Auto with TOD. Bought it new. It certainly was hands down the most SUV for the money when we bought it. Other than perhaps a Toyota 4-runner, the Trooper was about the only SUV that you could drive right off the dealers lot and go off-road. It also seemed to be the only SUV we test drove that actually did something when you stepped on the gas. It does a phenomenal job towing my 5000lb boat! Even 6 years later, I'm still pleased with the purchase.

    I change the oil and filter every 5k miles religiously. Starting around 50k miles....maybe even a few thousand miles after that, I started seeing some oil consumption. That was new to me. In the last 5k miles, its gotten to where I'm putting in a full quart every 1000 miles. A co-worker that has a Rodeo has mentioned a large amount of oil consumption as well.

    I have been perplexed, because I've never seen the first wisp of smoke come out the tailpipe. I've put in so much oil that if the oil was leaking into the coolant, I'd know because it would be overflowing! And obviously there is no oil leaking on the ground anywhere. Recently, both my wife and I noticed that the Trooper seemed to have lost some of it's "zip". All these symptoms led me to believe that I had a ring that had gone bad and was losing compression. I was pretty annoyed at that since we don't even have 60k miles yet. I've tried a couple of the "seal replenishing" type oil additives to see if it improved the consumption problem. It only seemed to get worse.

    After more reading here, I am glad to see that it appears to be a reasonably correctable problem, and not a more serious ring damage problem.

    I plan on doing a compression test this weekend and I think that will tell the tale. If I see good compression across the board, I'll go directly to Wal-Mart and get the CD2 Oil Detergent that has been recommended here. I may start using the "drive clean" type oils. I may even use some Mopar Combustion Chamber Cleaner!

    I've never been pleased with the fuel economy. My wife and I are both Engineers and have kept records of mileage at every single gas purchase. We've never seen the EPA 16/20 stickered. When gas prices started rising, I went back in the records all the way back to when it was new. I think the best mileage I ever saw was 17mpg. Now it mostly gets 13-14mpg, regardless of speeds, terrain, A/C on/off, etc. That is what it gets and that's all it's been getting for years. I'm going to clean the EGR and PCV hoses as best I can, along with a good fuel system cleaner, an ECM reset, and 93-octane fuel and see if there is any improvement.

    As for the Air Conditioning, I've always thought it was under powered. Our Trooper is black, and I live in brutally hot coastal Georgia. We typically have mid-90's temps with high humidity, resulting in heat indexes of 110-115 for three months. Not good conditions for any cooling system. The A/C is, at best, adequate. It eventually cools down the inside, but it may take up to an hour if the interior has been heat soaked for several hours in the sun. Keep in mind that the interior of the Trooper is absolutely cavernous compared to most other mid-size SUV's. It's just a lot of volume to cool.

    The only warranty work I've had is for a faulty sensor in the Evaporative Emission System. It was replaced, but I intermittently still get a Check Engine light. When I pull the OBDII code, it just says Evaporative Emission System Malfunction. I now wonder if it isn't related to the oil consumption problem.

    I've not been pleased at all with the dealer service. Any time I've had the Trooper in for service, there has been damage to the vehicle. I took it to get a short in the trailer pigtail fixed. They removed the jack and lug wrench to get at the harness, but never put them back...just left them in the cargo area.

    Another time, I had the A/C condensation back up into the passenger interior. I took it in, and the dealer claimed it wasn't a warranty item, just dirt in the drain tube. They charged me for the work to "clean" it, although having later looked at where the drain tube is located, I doubt it was dirty and they probably did nothing. I think the drain tube is too short, and condensation runs down the footwell and can leak in through a seam. I've added an extension to the tube and haven't had a single problem since. They had run one of the tire sidewalls against something and cut it up pretty badly. They claimed it was like that when we brought it in.

    When I had the problem with the EES, they had clearly bumped some tool stand or piece of equipment against the spare tire cover, scratching it badly in multiple places. After several complaints to Isuzu, the dealer called back weeks later and offered to "wax out the scratches". These were major gouges in the plastic, not scratches in the finish!

    That was the last time I took it in for service.

    I've not had any issues with the transmission or 4WD system. I just recently replaced the original tires and two of them still had plenty of tread left. I rotate every 10k miles or so.

    Those are my experiences! I hope to keep it at least 3-4 more years.
  • reply to my own post....

    I did the compression test this afternoon. Results were favorable. All six cylinders registered between 170 - 180 psi. Pretty good I'd say, and certainly seems to help rule out a leaky ring, bent valve, or bad seal.

    So while I had all the spark plugs out, I decided to do a major cleaning. I put Mopar Combustion Chamber Cleaner in each of the cylinders and am letting that sit overnight. I've had good results with it before. I usually let it sit and then vacuum out each cylinder with a wet/dry vac. I usually get some "black sand" type carbon material, plus it gets all the fluid out to prevent hydro-locking the engine!

    I'm also going to run some motor flush through and hopefully that will help loosen some of the crud and open up the holes in the rings that seem to be the cause of the oil consumption problem.

    Once the engine flush has run through, I'll drain the oil, and do an oil/filter change and put in some of the CD2 Oil Detergent that was recommended and replace all the spark plugs with new ones. I figured it was probably time to do so.

    I couldn't find any "once a year" fuel injector cleaner at Wal-Mart. I'm trying some "Large Vehicle" fuel injector cleaner and I'll run that through maybe three or four fill-ups in a row. I'll also reset the ECM and start using the 93 octane to see if fuel economy improves at all.

    Will report the results back here.
Sign In or Register to comment.