Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!





Lexus LS: Problems & Solutions

15758606263102

Comments

  • wwestwwest Posts: 10,706
    OEM equivalent purchased elsewhere than Lexus.
  • safasafa Posts: 5
    hello everyone,
    lexus ls400 1994 when I start the car my oil lamp (orange lamp) goes on and another problem is all of the lamps on the rear fenders left and right except the signal lamp don't work and I have one turned on light in my instrument that shows that they don't work I have checked the lamps and the fuse all of them were in good condition can somebody help me to fix my problems? also my oil is full

    thank you
  • My sister has a 1991 ES300 which we need to keep going (going through a messy divorce). The only problem is the rear air shocks on the car have failed (system leak) and they want big $$ for the shocks. Does anyone know if you can replace the air shocks with a regular shock (will it share a common shock with a Camery or another car?) The car has 300000 mile on it and it still drives great (except for the shocks leaking). I would appreciate the help because she cannot afford another car.
  • wwestwwest Posts: 10,706
    Doesn't have air shock....
  • paul29paul29 Posts: 178
    If the yellow indicator resembles an "alladin type" lamp then this is your oil level light. Your oil level does not need to be down very far for this to light . As you say the oil is at the full mark on tke stick then there must be a problem in the oil level circuit/switch .
  • cacmancacman Posts: 40
    Did you notice my reply to you on the TCS - It does light up when the car starts - thanks for your help
  • paul29paul29 Posts: 178
    The trac system by default is on every time you start the car . You manually have to disable it with the switch after starting every time if desired . When disabled the trac/off light should illuminate ( just a bit of information ). You can check the electronic side for codes by turning the ign sw on and connect the Tc and E1 connectors on the TDCL connector ( don't make a mistake doing this ) Then count the blinks on trac light for the code/s . You can physically check the system for activation by safely trying to spin the wheels on a slippery/loose surface If the trac system operates and the trac light illuminates then it may just be your trac switch/circuit that is suspect.
  • cacmancacman Posts: 40
    The traction system does seem to be operating fine. I have tested the system on snow, and all seems to be well with the system. The switch to turn the system off - does NOT seem to be working. When I toggle the switch ( near the ashtray) it does not appear to turn the system off ( the light on the dash does not light, and when I tested it in snow, it did not seem to override the TCS ) I was hoping it might be as simple as a fuse - probably not the case. Anyhow, thanks for all your help / advice.
  • deadairdeadair Posts: 10
    During the recent cold snap (0 and below), my 1993 400 LS display (MPH/Tach/ fuel) does not light up until the heater kicks in - first thing in the a.m. Should I be concerned? Is it a short or faulty fuse.
  • sv7887sv7887 Posts: 351
    Deadair,

      Sounds like a metal contact issue to me. Sounds like the metal contact contracts during the cold, and then expands once your heater kicks in. I had a similar problem with a Domestic car nearly ten years ago. Have a mechanic check all the connections. I doubt that's a serious issue.

    As for the ES300 Shock issue..
    Just get the parts from Irontoad.com or any dealer. The parts are inexpensive, and any competent independant mechanic can do the repair.

    Hope this helps,
    SV
  • bitkahunabitkahuna Posts: 206
    FYI, I don't believe the LS has a slip diff.
  • safasafa Posts: 5
    hi I have one problems with rear lamps on the rear fenders L/R side .both of them does not work and I have one turned onb light in instrument for that .I did chech bulbs ,they are ok I checked the fuse too,can any one help me
    thank you
  • sv7887sv7887 Posts: 351
    Hi All,
       Finally got the Engine Mounts replaced on the '92 LS. (Damaged in a 30 MPH side impact..Long story..) The dealer also found a cracked Coolant tank. The insurance company also agreed to fix it.
       So I only got the car back two days ago. I was wonderfully amazed with how the car ran. After 6 visits to the dealer in 8 weeks, I was finally satisified with the post accident repairs. I'd gotten two engine mounts, a new front bumper, LF quarter panel, and whole Left Front suspension out of it.
        Yesterday, I was driving, and the Tach Needle began to flicker, and with a puff of smoke shorted out. AHHHH! How much is this going to cost me this time? Or should I just sell the damn car?

    It's hard to believe, given the mileage on this car (87K). I know plenty of LS owners with 100K+ that haven't had these sort of problems. I bet the Lexus service guys are going to have a laugh tomorrow when I call them yet again...They in fact told me to sell the car after the 90K service...

    What do you LS owners think out there? Should I just pay up or replace it with something else?

    Sorry to whine about this car continously, but as you can tell, I'm really annoyed..It was PERFECT before that lady hit it!!!!

    Thanks,
    SV
    (
  • gardencargardencar Posts: 293
    After 154,000 miles and many years of faithful service, we decided to buy a new Lexus and retire our old LS. Just had it smogged for registration last year, when it passed with flying colors.

    This year, however, the state of CA added the dreaded NOX test. This is the most expensive and obnoxious test yet. To make a long story not so long, my car failed the NOX.
    Called around to the dealers and some independent shops and got quotes of $277 to $360 just to diagnose the problem and perhaps spend as much as $900 additionally if catalytic converters were needed. One shop even made the idiotic suggestion that I might need O2 sensors, another $600 to $900.

    Fortunately, had the problem diagnosed and solved at Prestige Auto in S.F. They replaced my EGR modulator valve and vacuum control valve. They were great guys and the service was terrific. Total cost, $427.00 including a new smog certificate.
  • Need to buy a rack and pinion set - how do you know if the rack and pinion set needed is the evo type $700.00 or the wo type $275.00, for a 1990 ls400
  • paul29paul29 Posts: 178
    All 1990 ls400's P/S rack & pinion are the evo type (electronic variable orifice). They are just asking if you want a new/rem pressure control valve (evo) with the new/rem unit or you are going to use your existing evo on it .
  • I am new to the board and would appreciate some clarification on replacing bulbs on the climate control module.

    I have a 93 LS 400 that has 1 or 2 bulbs burned out. Some postings indicated owners had found this unit to be sealed and were unable to replace the bulbs. Can anyone confirm that the 93 LS a control unit with replaceable bulbs.

    Also can anyone tell me where I can purchase these bulbs. It would be great if someone had a specific part number.

    Thanks

    pcsbob
  • cacmancacman Posts: 40
    Any thoughts after reading my post # 1208. Thanks for all your help, and your insight to various ?'s/problems.
  • paul29paul29 Posts: 178
    Sorry about that , from your reply in post #1208 I assumed you were going to leave it as is . Further , there are two trac bulbs , the trac/off bulb at the bottom of the cluster and the trac indicator bulb which indicates trac action in the center of the cluster , ( are both bulbs working when first turning ign sw on ? ) Now the Trac switch itself is just a grounding switch ie the switch just toggles the Trac function at the ecu on and off by grounding each time it is pushed . The trac function defaults to "on" after the bulb check every time you turn the ign sw on and the trac/off light goes off. I would remove the panel and check that the switch is plugged in , if someone has replaced bulbs/etc they could have left it unpluged , next at the switch check the w-b wire for continuity to ground , if good check continuity of y-g wire contact at the sw (wire unhooked) to ground with sw pushed , if good then the switch is ok . By pushing switch you are grounding the y-g wire which goes to the Trac ecu , try momentarily grounding this (y-g) wire with ign on and watch your trac/off light. Does it come on ?
  • '95LS, 150K...yes, the dreaded air shocks! Left rear drops as much as four inches overnight. Upon start up it inflates and works fine. Dealer replaced the shock...it now drops about two inches overnight. It's in there now for the third time. Good people, but there are no codes, and they do not see many with the air system.
    Love the car, just want it fixed.
Sign In or Register to comment.