Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!





2009 Toyota Corolla Problems and Repairs

14446484950

Comments

  • mcdawggmcdawgg Posts: 1,666
    JD Power Dependability Study

    This is the latest JD Power 3 year study - shows that for 2009 models (3 years old), Toyota got more awards (8) than any other maker. #1 Lexus (Toyota) #2 Porsche, #3 Cadillac And Toyota, #4 Scion (Toyota).

    Also note - for compact cars, the Prius was #1, #2 COROLLA. That's pretty good, considering the 2009 was the first year of a new generation of Corolla.
  • I have the same issue with my 2009 Corolla LE. It's a Japanese built model made in 2008.

    It first started after sitting for week; when I went to back out of garage the brakes seemed to be ceased and then let go with a "twang" and the ABS/Brake Light came on. The ABS/Brake lights went on/off intermittently but then stayed on steadily after a while.

    I’ve been to local mechanic four times so far as follows:

    1. Diagnostic Codes: CO210 ( Speed Sensor Failure - Right Rear)and C1238 Plug to Right Rear. Replaced plug to right rear, terminal repair kit and heat shrink. Result = ABS/Brake came right back on within 5 miles.

    2. Dianostic: ABS Light shows inactivity with left rear ABS sensor = Clean/apply electric grease to connections. Result = ABS/Brake light back on.

    3. Diagnostic: Clean/Apply Electric Grease to both Rear ABS Sensors. Drove 400ft and ABS/Brake light on again. Also occurring after the 2nd fix is disturbing noise from front of vehicle and vibration through brake pedal with light braking at low speeds.

    Mechanics now say this is the ABS module located in the engine compartment when it gets confused by the faulty ABS Sensor readings with the system thinking the rear wheels are slipping due to faulty ABS Sensor readings.

    Next option being suggested is replacement of complete Rear Wheel Hub Assembly because the female connection for the ABS Sensor is totally corroded resulting in female end of ABS Sensor not seating correctly within the hub. And the wheel bearings in the hub are ok but apparently all must be replaced as one unit to resolve.

    New Hub assembly from Toyota dealer quoted at $443 Retail but I'm researching a Koyo Wheel Hub Assembly -Rear (for Japanese Models) Part Number: W0133-1812555 for $172 through www.thepartsgeek.com.
  • I a 2009 Corolla LE. It's a Japanese built model made in 2008.

    It first started after the vehicle was sitting for week; when I went to back out of garage the brakes seemed to be ceased and then let go with a "twang" and the ABS/Brake Light came on.

    The ABS/Brake lights went on/off intermittently but then stayed on steadily after a while.
    I’ve been to local mechanic four times so far as follows:

    1. Diagnostic Codes: CO210 ( Speed Sensor Failure - Right Rear)and C1238 Plug to Right Rear. Replaced plug to right rear, terminal repair kit and heat shrink. Result = ABS/Brake came right back on within 5 miles.

    2. Dianostic: ABS Light shows inactivity with left rear ABS sensor = Clean/apply electric grease to connections. Result = ABS/Brake light back on.

    3. Diagnostic: Clean/Apply Electric Grease to both Rear ABS Sensors. Drove 400ft and ABS/Brake light on again. Also occurring after the 2nd fix is disturbing noise from front of vehicle and vibration through brake pedal with light braking at low speeds. Mechanics now say this is the ABS module located in the engine compartment when it gets confused by the faulty ABS Sensor readings with the system thinking the rear wheels are slipping due to faulty ABS Sensor readings. Next option being suggested is replacement of complete Rear Wheel Hub Assembly because the female connection for the ABS Sensor is totally corroded resulting in female end of ABS Sensor not seating correctly within the hub. And the wheel bearings in the hub are ok but apparently all must be replaced as one unit to resolve.

    New Hub assembly from dealer quoted at $443 Retail but I'm researching a Koyo Wheel Hub Assembly -Rear (for Japanese Models) Part Number: W0133-1812555 for $172 through www.thepartsgeek.com.
  • debbie70debbie70 Posts: 1
    I was looking through this because of a tire problem and was surprised by your remark about the noise. Our 2010 Toyota Corolla does the exact same thing. I have told mechanics and they say that until they hear it they don't know what to do. They say they can't find anything by looking. WELL the car makes a strange noise and the breaks vibrate. The first time I heard it, I thought I had hit a man hole cover. I was turning and going over a bump.
  • windgracewindgrace Posts: 83
    What is the tire problem? Is your Corolla going through tires, too? I put on a set of Michelin X radials after the goodyears wore out and after 6k miles the tires are already 1/4 worn. They are supposed to last 80k. The goodyears were replaced at 12k, but I figured they were crappy OEM tires.
    I think it's a suspension issue. I hear a loud clunk when the (front, I believe) tires hit a bump or pothole in the road while breaking. It sounds a little wobbly. And the brake pedal itself will shake violently. I've driven many types of cars over the same bumps in my road that 90% of the time cause this sound to happen in the Corolla without a single issue. No clunk or pedal shake. The dealership said it's the Corollas "superior" abs system in new models. Since the car has been in the shop several times I've driven many 2010 and 2011 toyotas (scion xd, prius, etc) and never got that bizarre sound. My moms 06 civic or 10 legacy with abs don't either.
  • terceltomterceltom Posts: 1,017
    edited March 2012
    I really think you got a lemon, :lemon: I have not had one issue with my 2009 Corrolla yet.
  • I too had some odd trany issues, with the worst being an abrupt shudder of the car (whole car jolted/shook). It wouldn't post a code, so the dealership said not their problem. Trany flush resolved the issue, likely related to a fluid issue and the lock-up torque converter. Happened under slight acceleration, usually coming off a ramp at highway speeds, though it occurred in other situations as well. Like I said, in my case a trany flush and fill resolved the issue, but it cost me $150 to have it done, despite being under warranty and with less than 60,000 miles on it, and that service not being required until about 100,000. Worth a shot, and not a bad thing (except for the price) as preventative maintenance in any regard. Good luck!
  • j06j06 Posts: 90
    2009 Corolla

    For the past few days I've noticed that after starting the car, the first few times I hit the brakes there is a significant "grinding" noise coming from them. Felt like the pads/rotors might come apart.. After the brakes are applied a few times, the noise disappears and the car drives normally. Is this an issue? Has anyone else encountered this problem before?. yesterday for the first few brakes there was a significant "grinding" noise. I parked the car for two hours then took a drive for 3 minutes. It was perfect and normal.

    Should I take out and clean all brake parts ?
  • MrShift@EdmundsMrShift@Edmunds Posts: 43,636
    I wouldn't take any brake parts out, just clean them off with "Brake-Kleen"--but if you are ambitious and want to sandpaper the brade pads to even them out a bit, that might be okay. I think this is related to both moisture build up on cold morning and the normal wear patterns (grooves, etc) of older brakes.
  • circuitsmithcircuitsmith Posts: 117
    edited March 2012
    Has it been rainy or damp where you are?
    Disk rotors can develop a thin layer of rust overnight that gets rubbed off after a few stops.
    This is normal.
    New cars that sit in front dealership for weeks can develop "lot rot", not so good on a test drive.
  • windgracewindgrace Posts: 83
    Yeah I think so too, but the problems are so numerous and abstract that I don't know if there's really anything I can do other than trade it in....which is a possibility. Hoping to trade it in for a Fit/Civic or Fiesta/Focus.

    Does anyone know what could cause that problem? Brake pedal shaking and an audible shudder under the car when either going over bumps or hitting potholes above 10 mph or so?
  • terceltomterceltom Posts: 1,017
    How about the Mazda 3, that's a really nice car also? If I wouldn't buy a Corolla it would be a Mazda 3.
  • mcdawggmcdawgg Posts: 1,666
    edited April 2012
    Hitting a big bump while braking will cause ABS to come on (brake pedal "shaking"). Normal.

    Civic or Fiesta - check Consumer Reports first.
  • windgracewindgrace Posts: 83
    Yeah, I was looking at maybe a used Mazda 3 (maybe stepping up to a Nissan Altima). But it almost seems worth going for a new Civic LX or Focus SE. I might be able to negotiate a deal with the dealership and I might be able to trade it in for a new Yaris or something. Right now I'm putting up with it and seeing what's happening with colleges before I make any decisions.

    It just seems odd that I have driven a handful of other vehicles with ABS and stability/traction control (thank the dealership rentals for all that experience! Scion xD, 2 different Priuses, and a Tacoma) over the same bumps with no pedal shake and no weird sounds coming from the suspension. But, what do I know.
  • j06j06 Posts: 90
    Re: Mr_Shiftright & circuitsmith

    Past Saturday I took a ride and found that with end of every stop there was significant grinding noise. I took to the nearest firestone shop. Replaced front pads with Wagner Ceramic for $105+ Tax (after $20 mail in rebate). All the noise is gone... The pads are quiet.
  • terceltomterceltom Posts: 1,017
    Probably a good idea to not allow your brake pads to wear down so low - surprised you didn't need rotors also because of grooving!
  • j06j06 Posts: 90
    edited April 2012
    You might be surprised, only 18K miles on the car. Dealer tech. requested to change the pads at 15K. I was in doubt so declined their advice. Also most of the dealerships charge $250 for standard brake service.
  • sjareasjarea Posts: 49
    Interesting. I have 15K with 25 months on '10 rolla and it has developed 'brake pad shift' IMO. Phuey cuz my '91 SR5 and '94 Camry never had such issues.

    Probably should just go ahead and switch mine out now. Ugh.
  • zzzcarzzzcar Posts: 3
    re: brake shake - ABS triggering. I have same issue with '06 corolla and know others that have same problem. I can hit cobble stones, small bumps etc and if 'im braking abs goes off...same problem on snow. when this happens there's very if any braking force making it to wheels...almost like coasting but with abs firing. i have had many other cars with abs, and this abs does not act like any of the others. imo it's not programmed right or there's some problem. In certain scenarios i have to pump brakes which is exact opposite of what you are supposed to do on other cars when abs triggers. I've learned to adjust to it. Otherwise car has been great. I did also suffer the 'ECM' failure but toyota covered that under recall at no charge.
  • kbrannon1kbrannon1 Posts: 1
    My car stalled at an intersection. After having it looked at by the dealer, I was told that the water pump had gone bad (which is out of warranty due to mileage), which caused my engine to seize up. I need to replace my entire engine on my 2 year old car! but they assured me it would only cost 4,000.00$ to put a new engine in! :( :mad: This is crazy! I have since read online that Toyota redesigned my water pump on my car. So, if they needed to change the design of it, then they KNEW there was a problem with the original design. Why is it that Toyota didnt do a recall? I am disgusted over this and will NEVER buy Toyota again! :lemon:
Sign In or Register to comment.