Mercury Mountaineer Key Fob

cwollercwoller Member Posts: 1
Recently I was trying to program an new FOB to work with my 2002 Mountaineer. The programming did not work and the one FOB that was working no longer works. I went to a locksmith and he tested the FOBs and they are transmitting a signal. He wasn't able to get it working either. I really don't want to go to the Ford dealer to fix this cause I know I will be charged significantly to repair it. Any ideas?

Comments

  • gonzivagonziva Member Posts: 1
    Disconnect the negative cable from the battery for a a minute, then reconnect; this should clear it up to a point where you should be able to program a good remote following the standard sequence, lock door, switch key from off to run 8x, then press any key on remote or remotes within 20 sec. good luck...
This discussion has been closed.