Crank sensor check engine light. Toyota Sienna.

eddieo56eddieo56 Member Posts: 6
edited October 2014 in Toyota
I just changed my timing belt and water pump. Car runs great but ck engine light came on for the crank sensor. Any ideas?
Tagged:

Answers

  • steverstever Guest Posts: 52,454
    What kind of Toyota? Year? Engine?

    Did you dislodge any wiring working on the engine?
  • eddieo56eddieo56 Member Posts: 6
    thanks for getting back to me so quick. There weren't many wires and I did reconnect everything. I did leave the ground loose for the first two test drives. I tighten it and turned the light off, got the light again. eddie
  • eddieo56eddieo56 Member Posts: 6
    It is an 05 3.3 sienna 107, 000.
  • Mr_ShiftrightMr_Shiftright Member Posts: 64,481
    What code # are you getting?
  • eddieo56eddieo56 Member Posts: 6
    p00016
  • eddieo56eddieo56 Member Posts: 6
    Could it be that I just missed a tooth on the belt? eddie
  • Mr_ShiftrightMr_Shiftright Member Posts: 64,481
    Well that's possible. That's the code you'd get if the timing belt slipped a tooth.

    I don't know if you disturbed the ECM harness at all, but the P016 can also indicate an ECM signal problem.
  • eddieo56eddieo56 Member Posts: 6
    Good evening, I just test drove the car. It runs perfect but when I shut it down and restart it the engine light and the VSC and Trac off light also light up. I changed the timing belt and water pump last week. I did forget to tighten the ground wire going to the motor mount till the next day. I would appreciated any ideas you may have. I'll check the timing marks tomorrow morning, but it runs so smooth, it hard to believe. And the VSCand trac light? Thanks again, eddie
Sign In or Register to comment.

Helpful Tools

Most popular vehicles