How do you adjust the side power sliding door cables on a Toyota Sienna 2001 minivan?

bbbb

Vehicle: 2001 Toyota Sienna LE minivan
Vehicle Subsystem: Passenger side power sliding door.

Problem: The power slider door opens half way, then tries to close, but fails to close within 6 inches. I have taken the cable assembly apart and discovered the steel wire shielding was jammed in the rear pully. Cleaned it all out.

Question: How do you align/adjust the steel cables in the unit. Putting it back together (what I recall as it was originally), the cables do not align. They are either to short or too long. Anyone have the procedure to adjust/align the cables?

Mr_Shiftright

You might have a read here. It's for a 2004 but hopefully basically the same procedure?

http://www.shareyourrepair.com/2014/01/how-to-replace-the-power-sliding-door-cables-2004-207-toyota-sienna-xle.html

Musevan

Bbbb did you figure this out? I have the same issue. What did you do?