-September 2024 Special Lease Deals-
2024 Chevy Blazer EV lease from Bayway Auto Group Click here
2024 Jeep Grand Cherokee lease from Mark Dodge Click here
2025 Ram 1500 Factory Order Discounts from Mark Dodge Click here
2024 Chevy Blazer EV lease from Bayway Auto Group Click here
2024 Jeep Grand Cherokee lease from Mark Dodge Click here
2025 Ram 1500 Factory Order Discounts from Mark Dodge Click here
Rebuilding My Kia Sportage Engine
Hello,
I am rebuilding a 2000 Kia Sportage engine. I know,,,hooray. At any rate, I had taken the block in to be boiled and the head to be resurfaced, valve seals, etc. any way when I picked up my stuff when it was done, they had to remove a bolt or two to be cleaned properly and put them neatly in a plastic bag, but also there was a very small hard rubber bushing in with it. I have know idea where it goes and the machine shop dont know either..So is this machine shop taking me snipe hunting or does this little bushing actually goes some where, Its about a 1/4" wide and about the same as high. I do have a pic of it, but,,how to post
I am rebuilding a 2000 Kia Sportage engine. I know,,,hooray. At any rate, I had taken the block in to be boiled and the head to be resurfaced, valve seals, etc. any way when I picked up my stuff when it was done, they had to remove a bolt or two to be cleaned properly and put them neatly in a plastic bag, but also there was a very small hard rubber bushing in with it. I have know idea where it goes and the machine shop dont know either..So is this machine shop taking me snipe hunting or does this little bushing actually goes some where, Its about a 1/4" wide and about the same as high. I do have a pic of it, but,,how to post
0
This discussion has been closed.
Comments
tidester, host
SUVs and Smart Shopper
and the picture: See more Car Pictures at CarSpace.com
I hope that helps.
tidester, host
SUVs and Smart Shopper
screams suspension. doubt its a bump stop then again i wouldnt know i never had them to begin with. i dont know of anything on the engine that would be like that. where did you find it and can u guess where abouts it fell off the kia?
give size next to a machinist rule and differnet views.
if it is small enough could it be a head valve oil seal ?
My comment: take another photo with a ruler beside.
Here is a web link that gave me lots of help with the timing, Im not familiar with an 06 but you make get some results here,,www.kiatechinfo.com , and http://www.headsonly.com if you need a new cylinder head..Very cheap and they pay the frieght.