Chevy S-10 Fuel injection problem

jeffery030jeffery030 Member Posts: 1
edited February 2014 in Chevrolet
I've been trying to figure this problem out for weeks now so please any input will be appreciated ! 1995 s10 2.2 auto, fuel pump went out so I installed a new one, started right back up and run long enough to warm up then dies. So I checked fuel, compression , and spark. It has it all but wouldn't start. I changed out the computer from identical truck, same issue. I've had the icm tested - good, installed new crank sensor- same deal, a friend told me to check for voltage at the injector- good, now I put my test light on positive post and put it to the pulse side of injector- the engine fires right up and runs normal for a while then dies again. Do the test light to positive - pulse side, it starts again. Any ideas , please!!!???

Comments

  • dans68gtdans68gt Member Posts: 1
    95 st 10  Chevy pickup  w vortex 4.3 motor, replaced fuel pump but gas doesn't seem to reach the motor. Pressure before and after good of the filter but motor won't start.  Is there sensors that I should be looking for? Thanks for any suggestions!
Sign In or Register to comment.

Your Privacy

By accessing this website, you acknowledge that Edmunds and its third party business partners may use cookies, pixels, and similar technologies to collect information about you and your interactions with the website as described in our Privacy Statement, and you agree that your use of the website is subject to our Visitor Agreement.