Chevrolet Teases 2015 Colorado Ahead of 2013 Los Angeles Auto Show

Edmunds.com

Chevrolet Teases 2015 Colorado Ahead of 2013 Los Angeles Auto Show

After a three-year absence, General Motors gets back in the midsize pickup game with the all-new 2015 Chevrolet Colorado, set for its global debut at the 2013 Los Angeles Auto Show.

Read the full story here

ne_blackshirts

Can't wait to hear what the details are Nov 20th. The midsized market needs a shot of energy and send a strong message to Toyota and Nissan the midsized market isn't just there's anymore. Just hope this isn't going to be some midsized truck that gets 15mpg and cost 40k if that's the case I'll skip and get a full size.

camarozone

A lot of questions, is this the same Colorado built in Asia that has two diesel options and if so will they offer the diesel. Stupid if they don't because they need what the others don't offer. Also Ford must be thinking - - "RANGER" or not until they see if the Colorado is a flop like the last one !

joe_scuba

Bet it's a Holden Colorado design.

rayzor

Ooh, I am so excited to see what this Colorado brings to the mid-sized truck segment. Back when I purchased my new 2011 Taco V6 4x4, Toy was really the only good choice then even thought I was not thrilled with the antiquated design.

Personally, I am ready to ditch my Taco which hasn't seen a major redesign or upgrade for nearly 8 yrs (still has drum rear brakes, no heated mirrors, no rear defrosters, same ancient V-6 and 5spd auto that gets 16mpg...). Only saving grace for Taco is its reliability...Even this is some what questionable. My Mexico built Taco has been back to the shop numerous times; loose weather seals, broken fan motor, defective interior trim pieces, defective sun visors, hard to start (this has never been resolved), defective factory roof racks, etc. All within the first year! And, yeah, its a rust magnet; after only one winter season, rust everywhere under the body and tiny rust spots on the paint everywhere and this is not covered by Toy; only if it rust thru the panels would they consider doing something for me...sigh...