93 Isuzu Rodeo exhaust y-pipe

Dominic7Dominic7 Member Posts: 1
edited April 2014 in Isuzu
I have a '93 Isuzu Rodeo 3.2L V-6 with an automatic transmission. VIN "V". I need the y-pipe that comes right before the catalytic converter & have been all over the internet with no success. This pipe has the braided flex hose built into it & a port for the O2 sensor as well. If anyone has any idea on how I can get one plz email me at dommega34@yahoo.com. Thanks!
Tagged:

Comments

  • tidestertidester Member Posts: 10,059
    plz email me at

    Why don't we just keep the conversation here so as not to deprive our dedicated members of valuable information? :)

    -tidester
    host SUVs and Smart Shopper
  • jimsrodeojimsrodeo Member Posts: 6
    I had the same problem with the stainless flex coupling rotting away and the Y pipe still intact. No one could locate a replacement for the Y pipe which was just as well because it probably would have cost about six hundred bucks.

    I located a replacement high quality replacement flex coupling from:

    EPI Inc.
    2777 E.83rd Place
    Merrillville, In 46410
    (219)942 0069

    Just measure your old flex coupling, I think it is 2 in dia in-out and 8 or 10 in length. It has been a couple of years but I think the part # was 38-150.

    I ordered it over the phone and It cost around thirty to thirty-five dollars including shipping.

    Cut your old flex joint off the Y pipe (leaving enough on the pipe) to slide the new one on and either clamp it or have it welded and it looks like factory install. Saves lots of headaches and bucks. You dont even have to remove the Y pipe to repair it.

    Jimsrodeo.
This discussion has been closed.

Helpful Tools

Most popular vehicles