Ford Edge Stalling
I was (and still am, I suppose) loving my 2008 Edge. However, yesterday, I experienced my first Edge glitch.
I started the engine and she immediately stalled. I found it a bit strange, but just restarted her up, assuming it was a fluke. She started up just fine, but when I put her in reverse, she started to buck and wouldn't really accelerate. I stepped on the gas, but found that I was really just coasting (engine was running, though). Then, when I switched into drive, she bucked again, the wrench symbol came on and she still would not accelerate. I pulled off to the side of the lot I was in and shut the engine off. I waited a few minutes and she started right back up and has been fine ever since.
I'm stumped. I don't know if I should take her in for service or not? If the wrench symbol lights, will that trigger a code for the dealer to know what went wrong or will my visit the dealer be a waste of time?
I read somewhere else online that someone experienced a similar issue and that their throttle positioning sensor was replaced (I think that's what they called it). Likely or not? What do you think?
Any advice would be greatly appreciated.
Kerri
I started the engine and she immediately stalled. I found it a bit strange, but just restarted her up, assuming it was a fluke. She started up just fine, but when I put her in reverse, she started to buck and wouldn't really accelerate. I stepped on the gas, but found that I was really just coasting (engine was running, though). Then, when I switched into drive, she bucked again, the wrench symbol came on and she still would not accelerate. I pulled off to the side of the lot I was in and shut the engine off. I waited a few minutes and she started right back up and has been fine ever since.
I'm stumped. I don't know if I should take her in for service or not? If the wrench symbol lights, will that trigger a code for the dealer to know what went wrong or will my visit the dealer be a waste of time?
I read somewhere else online that someone experienced a similar issue and that their throttle positioning sensor was replaced (I think that's what they called it). Likely or not? What do you think?
Any advice would be greatly appreciated.
Kerri
0
Comments