Starting Issue After Repair

lambert5lambert5 Member Posts: 1
edited December 2016 in Ford
Last night I changed the crankshaft position sensor on my 1999 Ford Windstar. While it was still on the the jack I checked to see if it would start and it did. This morning it will only turn over once and will not start. Even after jumping battery. Any ideas?

Comments

  • Mr_ShiftrightMr_Shiftright Member Posts: 64,481
    You mean it won't even crank over on the starter motor?
  • steverstever Guest Posts: 52,454
    Wonder if there's a bad ground or other wire that got stretched into place while it was jacked up but now isn't making contact? Probably just a coincidence though.
Sign In or Register to comment.

Your Privacy

By accessing this website, you acknowledge that Edmunds and its third party business partners may use cookies, pixels, and similar technologies to collect information about you and your interactions with the website as described in our Privacy Statement, and you agree that your use of the website is subject to our Visitor Agreement.